Franco Serblin Ktêma Loudspeaker Lab Report

Lab Report

The front-facing midrange drivers in this four-way flagship segue into the two rear-facing woofers at 135Hz, the upper mid cone extending its reach to 1.15kHz before crossing to the 28mm soft-dome tweeter. There's an increase in distortion from <1% through bass and treble to ~2% at this same midband frequency, and a resonant mode too [see CSD Graph 2, below], but this is quickly dissipated. Bass is well extended down to 25Hz (–6dB re. 200Hz) but the corrected, summed nearfield measurements [green area, Graph 1] were complicated by the combined reflex ports and side-venting – the alloy woofers peak at 66Hz while the dual ports are tuned to 60Hz with a useful output down to 20Hz (–3dB). Measured on the treble axis, the forward response shows a boosted mid/presence/treble rising +5.5dB from 1kHz-20kHz, but pair matching is an impressive 0.8dB, improving to 0.6dB from 200Hz-5kHz [black/red traces, Graph 1]. Leaving the elastic grille strands in place [blue trace] reveals ±1.5dB 'ripples' appearing between 2.5-6kHz. Audible? See Ken's listening notes!

Serblin's rated 92dB sensitivity is a trifle optimistic unless a full 200Hz-20kHz range is included in the measurement, the high treble lift boosting it to 89.1dB. Otherwise, the 1kHz/2.83V/1m figure is 87.7dB and the mean from 500Hz-8kHz closer to 88.8dB. It's unlikely the Ktêma will be partnered with an asthmatic amplifier, but it remains a reasonably current hungry load to drive. Serblin's quoted minimum of 3.2ohm was proved on test at 27Hz but there's a further drop to 2.8ohm at a very high 20kHz. Phase angles are moderate at +24o/–28o but the maximum impedance is just 8.0ohm/860Hz. PM

1020franco.lab1

Response inc. nearfield summed driver/port [green], freefield corrected to 1m at 2.83V [yellow], ultrasonic [pink]. Left, black; right, red; w. grille, blue

1020franco.lab2

Resonances are quickly suppressed with low-level modes remaining at 1.5kHz and 20-30kHz

Sensitivity (SPL/1m/2.83V – 1kHz/Mean/IEC) 87.7dB / 88.8dB / 87.0dB
Impedance modulus: minimum & maximum (20Hz–20kHz) 2.8ohm @ 20kHz, 8.0ohm @ 860Hz
Impedance phase: minimum & maximum (20Hz–20kHz) –28° @ 5.1kHz, 24° @ 415Hz
Pair matching/Resp. error (200Hz–20kHz) 0.8dB/ ±2.9dB/±3.3dB
LF/HF extension (–6dB ref 200Hz/10kHz) 25Hz / 35kHz/36kHz
THD 100Hz/1kHz/10kHz (for 90dB SPL/1m) 0.7% / 2.1% / 0.2%
Dimensions (HWD) / Weight (each) 1110x425x460mm / 55kg
Price £24,998

COMPANY INFO
Franco Serblin Studio
Vicenza, Italy
Supplied by: Absolute Sounds Ltd, UK
0045 9684 5100
ARTICLE CONTENTS

X